Security buzzer, Remote monito

· One device: Buzzer&Volume detection· Two device: Remote monitoring

1. Security buzzer function when using one terminal

(1) Set to mode

* Mode setting: is displayed

at the center of the upper part of the screen.

In the case of , hold down for a long time

(2) Sound Buzzer: Press and hold the red circle alarm button

at the center of the screen

(3) Stop the buzzer: Press and hold the red circle alarm button

at the center of the screen

Note) Buzzer operation is invalid during detection operation

2. When using one device Volume detection alarm function

(1) Set to mode

(2) Volume detection start: Press the "start detection" button

at the bottom of the screen

(3) Stop Detecting Volume: Press the [Detect stop] button

at the bottom of the screen

Remarks: When the application wants to close the screen during volume

detection There are two methods below.

No 1: Press the "Close Screen" button at the bottom left of the

screen. If it is detected that the set amount has been

exceeded at the screen redisplay, the automatic screen

redisplay.

Or press the "return" button of the terminal

No2: Press the terminal power switch

(press and hold to keep the power off).

To redisplay the screen, press the power switch again

Note 1: In this operation, the screen is not automatically displayed

even if the setting volume is detected.

Note 2: If the terminal power is off, please stop the application.

3. When using two devices 3. Remote volume detection alarm function

(1) Set monitoring device to mode.

(2) Set the receiving terminal to mode.

(3) Bluetooth pairing setting

Remarks: a.Please set the Bluetooth setting button on the upper left of

the screen of both terminals

Press alternately to select another device

b. Continue the above operations until "Bluetooth connection

succeeded" is displayed.

Or close the active application and restart this application.

  c. "Bluetooth connection succeeded" is displayed before and

after that Ignore English error messages

(4) Detection start operation: Press the "start detection" button at the

bottom of the reception terminal screen

(5) Stop the detection operation: Press the "stop detection" button at the

bottom of the screen of the receiving terminal

4. Setting of volume measurement condition

(1) Measurement interval: Time interval for measuring volume

(2) Continuous detection count within setting time

(3) Warning volume: If you set the volume to "0", no warning.

(4) Flash light: Set flash on/off to blink simultaneously

with the warning tone

This application uses camera and microphone features to flash and volume detect.