Fresh Ventilation

The Fresh Intellivent SKY bathroom fan.

Product information:

The Fresh Intellivent SKY bathroom fan, a completely ground-breaking, one-of-a-kind fan smarter and more powerful than anything that has come before. With a unique air quality sensor, unrivalled extraction capacity, and advanced moisture control, Intellivent SKY is optimised to produce a fresh and comfortable bathroom climate.

Default setting:

The fan comes ready to run with a factory setting, no need to change anything unless want too. From the start the fan runs on low continuous speed for basic ventilation (flow 10 l/s), the intelligent humidity control is activated at medium sensitivity (flow 28 l/s), afterrun timer with a 2min delay if connected to a signal live (flow 20 l/s), an airing function that starts every 26 hour and run for 1 hour (flow 20 l/s) if the fan has not been running or active this to refresh the air once a day. There are more function that can be activated manually on the fan touch panel or via the app.

Extra functions (not active by default):

As the first bathroom fan in the world the product has a build in air quality sensor that can easily be activated on/off via the touch panel, and via the app the sensitivity of the sensor can be adjusted into different levels easily (off, low, medium or high detection). The flow setting of the air quality sensor is shared with the humidity function (28 l/s default). Another build in function that easily can be activated via the touch panel on/off is a light sensor that reacts to light changes if someone walks into the room and activate the lightswitch etc. Light sensor sensitivity can then be adjusted via the app (off, low, medium, high detection), the flow setting is shared with the timer function (default 20 l/s) as what the light sensor do is to trigger the timer function.

Extra functions via app only:

Boost, the app has a button to activate the fan on full speed for 10 minutes when needed.

Pause, to stop the fan for a limited time there is a Pause button, pre-set 60min but can be adjusted, after the Pause the fan goes back to its normal mode.

Pairing the device and app:

Push once on the touch panel on/off symbol and then hold the light/air quality symbol for 8 seconds to activate Bluetooth mode, the symbol starts flashing, then continue in the app by press “Connect” on the paring screen, in a few steps your product is ready.

Basic app functions:

Press + symbol to add more devices, top right to of the first page to add extra devices into the same app.

Press (wheel symbol) top right on the main page for additional settings such as: Change name of product, Delete the product from the app or Reset function to factory default setting.

App main view:

Buttons to activate Boost or Pause.

Current running mode shown live with a small icon and the fan speed in rpm.

It shows activated functions as black and non-activated functions as grey.

There are separate pages for adjusting Timer, Humidity, Constant speed, Light sensor, Air quality sensor, Airing and Pause settings.

Adjustments via app:

On the separate pages for each function just click or move the slider for the individual preferred settings to adjust speed/airflow, sensitivity of sensors or various time settings.

Adjustments via panel:

Press the function icon and all adjustable/programmable symbols will light up. Then press any of the Timer, Humidity control, Continuous or Light/Air quality symbols. This will only light up the selected function, which is then ready for adjustment. Possibility to control speed/flow +/- is provided for certain functions. Lit lamps next to each symbol indicate the function selection. If no symbol is pressed for 15sec the light of the symbols stops.

Reset: Press the function button once. Press and hold the function button for at least 5 seconds. More information can be found in the product manual and ”Quick quide” online.