Citizen LinkServer

Citizen LinkServer helps you to set up Citizen label printers via USB.

Citizen LinkServer helps you to set up Citizen label printers via USB.

[Supported models]

Designated printer models, firmware versions are required (see below).

- CL-E300 (Firmware Version: EQxx0300 or later)

- CL-E300EX

- CL-E321 (Firmware Version: EQxx0300 or later)

- CL-E321EX

- CL-E303 (Firmware Version: ERxx0300 or later)

- CL-E303EX

- CL-E331 (Firmware Version: ERxx0300 or later)

- CL-E331EX

- CL-S521II

- CL-S531II

- CL-S621II

- CL-S631II

- CL-S700II

- CL-S703II

- CL-S6621

- CL-S700III

- CL-S703III

[Supported interface type]

- USB

The Android device must work as USB host to control the printer device. For example, you will need a so-called USB OTG (On-The-Go) adapter, which has a micro USB or Type-C male connector on the Android side (depending on your Android device) and a Type-A female connector on the other side. Then you can connect a regular USB cable for printer which has a Type-A male and Type-B male to connect to a printer.

[Example features]

- Checking printer information such as serial number or counters.

- Setting up printing controls such as printing speed, darkness or position.

- Setting up systems such as sensor levels or buzzer.

- Setting up media handlings such as cutter action.

- Setting up communication interface.

- Switching configuration presets.

- Managing access control.

- Printing test labels.

- Sending raw data to the printer.

- Updating firmware.

- Resetting the printer.

- Restarting the printer.

- Switching emulations.