aniCon

aniCon is an app to control aniLight product

Use aniCon to control your aniLight product via Bluetooth Low Energy (BLE), including changing device settings (such as Light brightness, RGB light color, White color temperature, Delay time, etc.) and performing Over-the-Air (OTA) firmware update to keep your device up to date.

First, you need to operate aniLight to enter BLE mode:

① Power aniLight off: Press and hold the left PWR button for 3 seconds until red light runs counterclockwise once.

② Enter BLE mode: Press and hold the right SET button. While SET button is held, press and hold PWR button for 3 seconds until BLUE (not green) light runs clockwise once. Then release both buttons.

Go to SCAN tab to scan and find aniLight device with the name of "aniLight_1". Tap it to connect. The BLE icon in the top-right corner will turn to active after connected. Tap that icon to connect/disconnect it.

Go to DEVICE tab to change its name or perform firmware update.

Go to ANILIGHT tab to change settings of the connected aniLight.

You need to press the SAVE button to save your changes to the device.

Go to Help tab for more detailed information.

BLE mode needs more power to run. So after finishing the settings change, re-enter the normal mode:

① Power the unit off.

② Power the unit on normally: Press and hold PWR button for 3 seconds until green light runs clockwise once.

We are now working on an improved firmware, and will release it soon in the next version.