192.168.1.1 - [ 192.168.l.l ] admin - login

192.168.1.1 - 192.168.l.l admin login default admin and password router list.

192.168.1.1 - 192.168.l.l router login admin and wifi password change router. Router IP address list and default router password list. Tp link, Netgear, Asus, Linksys, D-Link, Tenda and all router lo gin.

How to Login to 192.168.l.l ?

To login into 192.168.1.1 follow these steps –

Open a web browser and go to http://192.168.1.1 or type 192.168.1.1 into the browser’s URL bar.

A login page will appear asking you to enter the login username and password.

Enter the username and password in the designated fields.

You will now be logged in into the Admin Panel of the router.

Note: If you are unable to access the router’s admin panel at 192.168.1.1, try using a different IP address – 192.168.0.1 or 10.0.0.1.

Forgot IP Address Username and Password?

If you have forgotten the IP Address Username and Password or if they are not working then you can –

Look at the manual/box or back of router. (or check default username and password list).

If you changed the password and have lost it or forgotten it then you need to perform a factory reset. To do that, look for a small hidden RESET button on the back of your router. Press and hold that button for about 10-15 seconds using a paper clip or a needle. The router will reboot itself and will be back to default settings.

How to Change Route IP Address?

The default gateway IP address comes pre-assigned by your internet service provider, however, a user can configure it par to needs. It is often changed to prevent bad guys access your admin panel, prevent DDoS attacks, or just to add an additional layer of safety. Here’s how to do it –

TP-Link:

Login to your default admin panel at 192.168.0.1 or 192.168.1.1 (admin/admin is username and password)

Go to Advanced settings > Network > LAN.

Under “IP Address” field you may change it to your desired address such as 192.168.1.2.

Save it and the router will reboot to apply the changes.

D-Link:

Login to your router configuration page (username: admin & password: admin/blank)

Go to Setup > Network Settings.

Now you will find Router IP Address field.

Change it as preferred and Save Settings.

NETGEAR:

Login to NetGear router settings page via 192.168.1.1 or 192.168.0.1 or you can access via http://www.routerlogin.net or http://www.routerlogin.com.

By default, the username is admin and password is password.

Once logged in navigate to Advanced > from left side menu go to “Setup” > LAN Setup.

Under LAN TCP/IP Setup, you will see IP Address. Change 10.10.10.1 as preferred.

Apply Changes and the system will reboot to update settings.